Park Electrochemical’s Neltec Business Unit Appoints Steve Lach as President


Reading time ( words)

Park Electrochemical Corp. announced the appointment of Steven N. Lach as president of Neltec Inc., Park’s electronics business unit based in Tempe, Arizona. In this position, Mr. Lach will report to Chris Mastrogiacomo, president and chief operating officer of Park Electrochemical Corp.

Lach has had an extensive career in the printed circuit board industry, and has served in senior management positions at Sanmina Corporation, Continental Circuits Corporation and Hadco Corporation.

About Park Electrochemical Corp.

Park Electrochemical Corp. is a global advanced materials company which develops and manufactures advanced composite materials, primary and secondary structures and assemblies and low-volume tooling for the aerospace markets and high-technology digital and RF/microwave printed circuit materials principally for the telecommunications and internet infrastructure, enterprise and military markets. The Company’s manufacturing facilities are located in Kansas, Singapore, France, Arizona and California. The Company also maintains R&D facilities in Arizona, Kansas and Singapore.

Share

Print


Suggested Items

EPA, Industry Come Together in Visit to TTM Facility

07/18/2019 | Kelly Scanlon, director, EHS policy and research
IPC member TTM Technologies is proud to show off the new wastewater-treatment system at its Sterling, Virginia plant, which is helping to enhance the company’s pollution prevention and resource recovery performance.

Dissecting the IPC Regional Survey on PCB Technology Trends

07/15/2019 | I-Connect007 Editorial Team
Sharon Starr, Denny Fritz, and Mike Carano talk about the global 2018 IPC Technology Trends Report released early this year—the size of the survey, how it was conducted, the general findings, and regional differences. They also shared their takeaways and regional insights, and the industry outlook over the next five to 10 years.

Identifying Product Board Class and Pre-quote Software

07/09/2019 | Mark Thompson, CID, Prototron Circuits
Deciding on the class of the final product will determine what files are needed for fabrication and assembly. It is critical to note that for a product to be built to any class level, it must be designed to that class level from its inception.



Copyright © 2019 I-Connect007. All rights reserved.