High-end CCL Demand from Huawei Ramping Up


Reading time ( words)

High-end copper clad laminate (CCL) demand from Huawei has been rising due to a major redesign of its 5G base station infrastructure, prompting Taiwan CCL makers to upgrade their CCL specs to meet the demand.

To wean itself off US suppliers for related IC products, Huawei has since June moved to re-design its 5G base station IC modules and cut orders for CCL for use in active antenna unit (AAU) from major US supplier Rogers while seeking alternative supply sources for such CCL.

Share

Print


Suggested Items

Vertical Conductive Structures, Part 3: Design Tool Techniques

08/23/2019 | Ed Hickey and Mike Catrambone, Cadence Design Systems, and Joan Tourné, Nextgin Technology
New vertical conductive structure (VeCS) technology can reduce layer count and improve signal integrity without the need for sequential technologies. VeCS is different than traditional through-hole vias, microvias, and ELIC designs, which are more expensive and require a high number of laminations, drilling, and plating cycles to build up a reasonable number of layers.

Solder Mask Curing: UV Bump Overview

08/19/2019 | Nikolaus Schubkegel
Ultraviolet (UV) bump, also called UV cure, is a processing step in which the solder mask pattern is irradiated with ultraviolet and infrared light. This step is performed with special equipment that is built as a continuous flow system, which consists of a conveyor belt and tubular UV lamps mounted above and below the belt. Read on to find out more about this process.

Avoiding CAF Failures at the IPC High-reliability Forum

12/31/1969 | Andy Shaughnessy, I-Connect007
Foresite CEO Terry Munson recently spoke with Andy Shaughnessy during the IPC High-Reliability Forum and Microvia Summit in Baltimore about his presentation on the causes of conductive anodic filament (CAF), the dangers of resin starvation, and what advice he'd give to PCB designers to avoid those types of failures.



Copyright © 2019 I-Connect007. All rights reserved.