Decreasing Bend Radius and Improving Reliability—Part I


Reading time ( words)

Application: Design guidelines to improve the flexibility and reliability of flexible circuits.

Many of the issues that arise when using a flex circuit come from a lack of knowledge about how to properly design one, especially when the circuit is required to bend. Many novices will design a circuit that calls for bending the flex in too tight of a bend radius, which can cause damage to the circuit and lower the reliability of the end product. This series of articles will focus on the seven key aspects to consider when designing for maximum durability and maximum “flexibility.” It is important to know that because flexibility is a relative term, this study will instead use the phrase "reducing bend radius." Here are two of the seven design strategies (please see Part II and Part III for more tips):

1. Reduce overall thickness:

IPC guidelines typically list minimum bend radius of 6X the circuit thickness for single-sided flex, 10X for double-sided flex, and 20X for multiple layer flex. The area of focus is the thickness where flexing or bending will occur, which should be only in a location with conductors and not plated through-holes. Thickness can best be reduced by:

A. Using thinner copper

B. Using adhesive-less base materials

C. Stagger conductors

D. Specifying button plating or pads only plating

Any flex circuit with plated through-holes will need to be either panel plated or button plated. Button plating is preferred because it only plates the vias and leaves the conductors un-plated and which does not increase the thickness.

2. Use only rolled annealed (RA) copper:

There are two common types of copper; rolled annealed (RA) and electro-deposited (ED) copper.

A. Rolled annealed copper is best for achieving a tighter bend radius.

B. It is also important for you to put on your drawings the direction of the grain in relation to where the tight bending will occur.

flex.jpg

Go to Part two of this article.

Share

Print


Suggested Items

EIPC Technical Snapshot Review: Semi-additive Processes

12/01/2021 | Pete Starkey, I-Connect007
The development of ultra-high-density PCBs and packaging substrates using semi-additive and additive manufacturing processes was the theme of the 13th Technical Snapshot webinar presented by EIPC on November 24. It was introduced and moderated by technical director Tarja Rapala-Virtanen. Daniel Schulze, application engineering manager at Dyconex in Switzerland, gave the opening presentation, “Advanced high density rigid packaging substrates for RF and miniaturization.” He explained that with their long-established capabilities in ultra-high-density PCBs in flex, rigid-flex and rigid multilayer technologies, it was logical for Dyconex to apply their expertise to the development of specialist IC substrates.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

04/23/2021 | Andy Shaughnessy, I-Connect007
This week, we bring you a wide swath of news, columns, and articles from the past week. Altium announced a new cloud platform that connects design stakeholders with users of its Altium 365 environment. Cadence Design Systems has acquired a company that develops computational fluid dynamics technology to help expand its system analysis offerings.

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

03/05/2021 | Nolan Johnson, I-Connect007
A perennial and yet irregular category on the popular game show Jeopardy is “potpourri.” My dad, as I was growing up, pronounced the word as “pot-poury.” It wasn’t until I was a sophomore in college that my girlfriend’s mom—who had a penchant for a soupcon of French euphemism in her tête-à-têtes—pronounced the word properly: “po-pu-ree.” Such are the risks of growing up just a bit rural.



Copyright © 2021 I-Connect007. All rights reserved.