Just Ask Happy: Monitoring Via Reliability on a Lot-by-Lot Basis


Reading time ( words)

We asked for you to send in your questions for Happy Holden, and you took us up on it! The questions you've posed run the gamut by covering technology, the worldwide fab market, and everything in between. Enjoy.

Q: What is the best way to monitor microvia reliability on a lot-by-lot basis for high-volume production?

A: What I recommend, and practice, is this: Do a thorough qualification of a fabricator using a HATS Qualification Panel (an IPC PCQRR-like panel) that includes an IPC D coupon resized for the runner on your SMT panel. Run these panel coupons through IPC-TM-650-2.6.27B and then TM-650-2.6.7.2 thermal cycles for 500 cycles. This is your baseline.

Then, by incorporating this smaller D coupon on all your boards’ assembly runners—requiring each lot to have a plating process control coupon for X number of solder float tests at 288°C and then microsections to look at TH quality—you have a way of comparing that lot’s performance to your initial qualification for that vendor. This should be redone each year and kept for records on each lot in case needed later.

To pose your own question for Happy Holden, take the survey by clicking here.

Share




Suggested Items

Michael Carano: A Focus on Process Control, Part 2

09/28/2022 | I-Connect007 Editorial Team
In this second half of our conversation, Michael Carano discusses some of the metrics that fabricators need to consider before investing in new processes, especially process control technologies, and some of the challenges board shops face updating brownfield sites.

EIPC Technical Snapshot: Novel Laser-based Manufacturing Processes in Automotive Electronics

09/22/2022 | Pete Starkey, I-Connect007
“Summer is over, now it's back to work!” This was the opening line of the invitation to the 18th EIPC Technical Snapshot webinar, Sept. 14, following the theme of advances in automotive electronics technology, introduced and moderated by EIPC President Alun Morgan. The first presentation, entitled "The fully printed smart component—combining additive manufacturing and sensor printing," came from Jonas Mertin, a thin-film processing specialist at the Fraunhofer Institute for Laser Technology.

EIPC Summer Conference 2022: Day 2 Review

06/29/2022 | Pete Starkey, I-Connect007
Örebro, Sweden on June 15 brought a bright and early start to Day 2 of the EIPC Summer Conference for those who had enjoyed the previous evening’s networking dinner, but had resisted the temptation to over-indulge or to carry on their long-awaited catch-up conversations with old friends into the small hours. All but a few were in their seats for 9 a.m., awake and attentive for Session 4 of the conference, on the theme of new process technologies, moderated by Martyn Gaudion, CEO of Polar Instruments.



Copyright © 2022 I-Connect007. All rights reserved.