Winonics Invests $3.9M in Equipment for Lean Six Sigma Renovation


Reading time ( words)

Winonics Brea, an Additive Circuits Technologies, LLC company, is pleased to announce its “Facility Master Plan.”

Winonics has set out to differentiate itself by investing approximately $3.9 million in to a facility-wide renovation plan that includes extensive equipment and technology upgrades along with infrastructure improvements that are grounded in the principles of lean manufacturing and lean six sigma disciplines.

The Facility Master Plan offers a vision into advanced technology PCB fabrication with the expectations of creating a world-class PCB manufacturing facility and a research and development center for the company’s patented additive manufacturing technology.

“We are investing in our four pillars; equipment and technology, people, process, and methodology,” said David Torp, Winonics’ CEO.  “When fully executed the plan is transformative and will set a new standard for PCB manufacturing; placing Winonics among the top advanced technology providers in the country.”

The plan, which will support Winonics’ strategic plan priorities and facilitate the commercialization of the company’s additive manufacturing technology, is expected to be completed in the first quarter of 2022.

Share

Print


Suggested Items

A Conversation with Canice Chung, TTM Technologies

12/09/2014 | Barry Matties, I-Connect007
We had the opportunity to sit down with Canice Chung, Executive Vice President of TTM Technologies, Inc. to discuss the current trends and challenges of PCB Manufacturing in China.

A Conversation with Laurent Nicolet, Schmid Group

12/07/2014 | Barry Matties, I-Connect007
During the HKPCA & IPC Show 2014, Laurent Nicolet, VP - PCB Business Unit of Schmid Group took a few minutes to discuss the automation technology that was on display and share the changes he's seen in the China market.

Thin PCBs for Smart Phones: Technology and Reliability Considerations

11/19/2014 |
The next generation of smartphones will demand very thin multilayer boards to reduce product thickness. This paper shows three different manufacturing approaches which can be used for very thin, any-layer build-ups. The technological approaches are compared on reliability level--the any-layer copper filled microvia technology which is to be considered state-of-the-art for high-end phones and the ALIVH-C/G technology well established in Japan.



Copyright © 2021 I-Connect007. All rights reserved.