Tighter Scrutiny Needed for PCB Cleaning Agents


Reading time ( words)

PCB cleanliness on the assembly floor is now getting more attention, due to tiny residues and contaminants being left on assemblies after new, advanced assembly processes. Cleaning methodologies, testing, analysis, and special chemistries are being taken to a new level to assure customers of ultraclean boards to avoid costly latent issues.

Board cleanliness is especially critical for mil/aero and medical applications. The right types (and amounts) of cleaning agents must remove flux residues to assure the integrity of processes such as bonding and conformal coating. During the coating process, if residues result in poor wetting or delamination, they can cause assembly failures and ultimately lead to field failures.

In today’s assemblies, there are growing numbers of advanced packages like land grid arrays (LGAs), fine pitch BGAs, micro BGAs, micro CSPs, and the list goes on. Packages such as LGAs are flush to the board, and they have bumps, not balls or spheres, like BGAs.

If a small amount of flux remains trapped under the board’s surface, it can change the characteristics of impedance, resistivity. This could also change what could have been a perfect eye diagram, and in general, change the optimal level of operation. Ultra cleanliness is even more critical if underfill or conformal coating is applied to a device.

It’s difficult to clean such a device after the board has been processed. Therefore, assembly personnel have to be absolutely sure they’ve taken every possible measure to assure devices and boards are ultraclean. If residues are left in the conformal coating or underfill, then these contaminants are trapped inside the capsule and hinder device performance.

Read the full column here.


Editor's Note: This column originally appeared in the April 2014 issue of SMT Magazine.

Share




Suggested Items

Book Excerpt: 'The Printed Circuit Assembler’s Guide to… Solder Defects'

06/07/2022 | I-Connect007 Editorial Team
Solder defects in surface-mount technology (SMT) assembly have been an issue for decades. Further, the combined challenges of Pb-free soldering and ever-increasing miniaturization have resulted in new or exacerbated defects in electronics assembly, but there are proven ways to avoid defects. This book will be especially beneficial to PCB assemblers in improving their assembly processes and the reliability of the end-product, eliminating field failures, and reducing costs.

How to Minimize Quoting Time and Increase Accuracy in EMS Production

03/30/2022 | Mark Laing, Siemens Digital Industries Software
New product introductions (NPIs) and customization have been increasing rapidly over the past few years—with the results that the already-small profit margins in electronics assembly are shrinking even further. Fifteen years ago, the PCB was the product. Today, most products are a system, with multiple PCBs, cables, and enclosures. Many manufacturers want to provide turn-key products that have multiple BOMs, making the assembly process even more complicated.

A Hard Look at Strategic Chip Investment

03/03/2022 | I-Connect007 Editorial Team
Jan Vardaman is a key contributing author to an IPC report detailing the capabilities gap in advanced packaging capabilities in the U.S. manufacturing ecosystem. We talked with Jan about the report and the current dynamics in the U.S. market. Jan’s comments provide additional detail and insight to the findings published in the report.



Copyright © 2022 I-Connect007. All rights reserved.