The Plating Forum: ENIG and the Plating Process


Reading time ( words)

Electroless nickel immersion gold (ENIG) continues to gain market share due to its versatility in a wide range of component assembly methods including solder fusing, wave soldering, and wire bonding. The ENIG finish provides a highly solderable flat surface that does not tarnish or discolor. It has a long shelf life and the precious metal topcoat provides excellent electrical continuity. The nickel serves as a barrier against copper diffusion and prevents copper contamination of the solder during wave soldering and rework operations.

The ENIG Plating Process

The plating of ENIG is a complex multi-step process. Each process step is carefully designed and must be well understood and controlled to produce the desired end product.

These can be broken down into the following:

  1. Preparing the catalyzed surface for Ni deposition
  2. The Ni deposition step
  3. The gold deposition step

1. Preparing the Catalyzed Surface for Ni Deposition

The objective is to form a thin immersion uniformly distributed palladium catalyst layer on the copper surfaces to be plated with nickel. Nickel deposition is specific to the catalyzed surface. Nickel will not initiate or deposit on non-catalyzed surfaces like soldermask or laminate. The uniformity is important so that the nickel will initiate at the same time on all areas of the copper surfaces to be plated. This will give rise to an even nickel deposit with no crevices or protrusions in the final plating. An even nickel deposit is not susceptible to corrosion during the gold deposition step.

Achieving a uniformly catalyzed surface begins with bringing a pristine copper surface to the catalyst bath. A pristine copper surface is one that is free of oxidation, organic contaminants, neutral (charge-free) and fairly smooth (low profile). Read the full column here.
Editor's Note: This column originally appeared in the December 2013 issue of The PCB Magazine under George's "The Finish Line" column.

Share




Suggested Items

The Carbon Footprint of HDI: Direct Metallization vs. Electroless Copper

04/14/2022 | Jordan Kologe and Leslie Kim, MacDermid Alpha Electronics Solutions
As the electronics supply chain contends with the struggles of moving out of the pandemic and into a new normal, it is increasingly obvious that a new normal will be one with sustainability and resource conservation as the top priority. Over the past year, we have seen printed circuit board manufacturers encounter challenges associated with environmental regulations, water and power outages, and pressures from the supply chain to reduce environmental footprints. From the perspective of a board fabricator, especially one that specializes in HDI, a highly resource-intensive step in the process of making a printed circuit board is the primary metallization step. All circuit boards that have multiple layers go through such a primary metallization, which is either electroless copper or direct metallization (DM).

EIPC Technical Snapshot: A European Roundup

03/02/2022 | Pete Starkey, I-Connect007
Although it was originally proposed to hold a one-day face-to-face EIPC conference in Frankfurt, travel restrictions in Germany made this impractical. But the Technical Snapshot webinar format has proved so successful that it was decided to run an extended version as an alternative—two sessions, with three presentations each. It worked extremely well. The carefully selected program on February 23 featured excellent speakers, and seamless organisation added up to an outstanding event.

Catching Up With RBP Chemical and Schlötter

01/20/2022 | Dan Beaulieu, D.B. Management Group
It’s always great to see two very good companies form a mutually beneficial alliance. I was lucky enough to watch this particular strategic partnership come to fruition this year between RBP Chemical and Schlötter. I wanted to talk to both companies, so I sat down with Matthias Hampel, global executive representative-PCB and electronics at Schlötter, and Ernest Litynski, president of RBP Chemical Technology, to get the inside story.



Copyright © 2022 I-Connect007. All rights reserved.