AT&S AG Proposes Dividend of EUR 0.36


Reading time ( words)

At today’s supervisory board meeting, the supervisory board and the management board of AT&S Austria Technologie & Systemtechnik Aktiengesellschaft decided to propose the following appropriation of the company’s profit of EUR 36,874,815.29 stated as of 31 March 2015 (whereof distributable: EUR 24,502,815.29) to the Annual General Meeting on July 9, 2015.

A dividend of EUR 0.36 per share should be distributed to the no-par shares outstanding on the payment day and entitled to a dividend, and the remaining amount of EUR 22,888,815.29 should be carried forward. In relation to the share price at the reporting date on 31 March 2015, this would correspond to a dividend yield of 2.46%.

Based on the excellent development in the financial year 2014/15, shareholders can participate in the company’s success. For the financial year 2013/2014, a dividend amounting to EUR 0.20 per share was paid out. The final decision regarding the appropriation of the company’s distributable profit rests with the Annual General Meeting. The 21st Ordinary General Meeting of AT & S Austria Technologie & Systemtechnik Aktiengesellschaft will take place on 9 July 2015, at 10:00 a.m, at Montanuniversität Leoben.

Further information on the Annual General meeting will be available on the website (Section Investors > Annual General Meeting) by 18 June 2015.

Share

Print


Suggested Items

Vertical Conductive Structures, Part 3: Design Tool Techniques

08/23/2019 | Ed Hickey and Mike Catrambone, Cadence Design Systems, and Joan Tourné, Nextgin Technology
New vertical conductive structure (VeCS) technology can reduce layer count and improve signal integrity without the need for sequential technologies. VeCS is different than traditional through-hole vias, microvias, and ELIC designs, which are more expensive and require a high number of laminations, drilling, and plating cycles to build up a reasonable number of layers.

How to Feed Test Data Back to Engineering for Process Improvement

08/01/2019 | Todd Kolmodin, Gardien Services
Some people think of the PCB manufacturing process as a black box: design data goes to the manufacturer (fabrication house), and magically, the finished PCB is produced. While it may have been like that in the past, in actuality, fabricating PCBs today is quite a ballet of processes.

Avoiding CAF Failures at the IPC High-reliability Forum

12/31/1969 | Andy Shaughnessy, I-Connect007
Foresite CEO Terry Munson recently spoke with Andy Shaughnessy during the IPC High-Reliability Forum and Microvia Summit in Baltimore about his presentation on the causes of conductive anodic filament (CAF), the dangers of resin starvation, and what advice he'd give to PCB designers to avoid those types of failures.



Copyright © 2019 I-Connect007. All rights reserved.