SHENMAO Introduces BGA and Micro BGA Bumping Solder Paste


Reading time ( words)

SHENMAO Bumping Solder Paste PF608-PI-21 (Sn/Ag4.0/Cu0.5/x) and PF606-P-BS1 (Sn/Ag3.0/Cu0.5/x) aim to decrease voids in wafer bumping process. SHENMAO MICRO MATERIAL INSTITUTE applications engineers focused on developing the Bumping Solder Paste Formula with excellent stencil printing transfer rate and the lowest Void (<10%) to optimize manufacturing process performance. The world’s largest IC Packaging and Test Service OSAT utilize SHENMAO Bumping Solder Paste in production.

As the World’s Major Solder Materials Provider, SHENMAO produces SMT Solder Paste, Wave Solder Bar, Solder Wire and Flux, Solder Preforms, Semiconductor Packaging Solder Spheres, Wafer Bumping Solder Paste, Dipping Flux and PV Ribbon.

For more information, please contact:

SHENMAO America, Inc. www.shenmao.com; Tel: 408-943-1755   e-mail: usa@shenmao.us

Share

Print


Suggested Items

3D Additive Electronics Manufacturing: Are We Nearing an Inflection Point?

05/28/2020 | Dan Feinberg, I-Connect007
Recently, Dan Feinberg was invited to attend a detailed and broadly informative webinar by nScrypt titled “The Strength of 3D-Printed Electronics," which covered the status and advances in the use of 3D printing for electronic device design and manufacture. nScrypt is an Orlando-based company founded in 2002 that focuses on 3D printing. Here’s what Dan learned from each of the speakers.

IPC Europe Shares Technical Education and Standards Awareness

04/22/2020 | Pete Starkey, I-Connect007
Against a background of COVID-19 uncertainty and unprecedented challenges, but recognizing the vital importance of continuing to educate engineers and share the knowledge and skills required to manufacture boards and assemblies of the highest yields and reliability, the IPC Europe team hosted a technical webinar for the European electronics industry, featuring the expertise of two of I-Connect007’s regular columnists: Mike Carano and Jan Pedersen. Pete Starkey provides an overview.

PCB Surface Preparation Before Solder Mask on Non-copper Finishes

04/08/2020 | Nikolaus Schubkegel
A circuit board is made of copper. Usually, final finishes are applied after the solder mask process. In some cases, for special applications, the final finish may be applied before solder mask. In this case, we have solder mask on ENIG or galvanic nickel-gold. It is also possible to have tin or tin-lead under solder mask; this was an old technology that no longer plays a role today.



Copyright © 2020 I-Connect007. All rights reserved.