Roundtable Discussion: App Notes and Fab Notes


Reading time ( words)

Andy Shaughnessy recently invited four recent contributors—Dana Korf, Jen Kolar, Mark Thompson, and Kelly Dack—to review the June and August 2020 issues of the Design007 Magazine, which covered app notes and fab notes, respectively. In this wide-ranging roundtable, the group discusses some of the ongoing challenges related to incomplete and inaccurate design data and why communication can preclude many of these problems.

What follows is the PDF booklet version of the transcript from this conversation, which originally appeared as a video feature in September 2020.

To download the booklet to your library and read this roundtable, click here.

Share

Print


Suggested Items

IPC-2581 Revision C: Complete Build Intent for Rigid-Flex

04/30/2021 | Ed Acheson, Cadence Design Systems
With the current design transfer formats, rigid-flex designers face a hand-off conundrum. You know the situation: My rigid-flex design is done so now it is time to get this built and into the product. Reviewing the documentation reveals that there are tables to define the different stackup definitions used in the design. The cross-references for the different zones to areas of the design are all there, I think. The last time a zone definition was missed, we caused a costly mistake.

Turning ‘Garbage In, Garbage Out' into ‘Good In, Good Out’

03/23/2021 | Tamara Jovanovic, Happiest Baby
In the PCB design cycle, it is so easy to unintentionally introduce “garbage” into your system. Unless you have time to extensively check everything you bring in from an external source, it is very likely that something will not match up with your design data. In the end, this means you’ll have to put more work into your design and basically reverse-engineer a part that was supposed to save you time and effort.

Karen McConnell: Recipient of the IPC Raymond E. Pritchard Hall of Fame Award

03/11/2021 | Patty Goldman, I-Connect007
"I heard about IPC when I started a new job at UNISYS after graduating college. I moved from ASIC design to printed circuit boards," said Karen McConnell after being inducted into the Raymond E. Pritchard Hall of Fame. "At the time, in the late ’80s and early ’90s, there were rumors going around that printed circuit boards were going to disappear, and ASICs were going to take over the world. But something in printed circuit boards fascinated me. I minored in robotics in college as an electrical engineer and the data used to fabricate, assemble and test the boards is actually all robotic language. I was hooked."



Copyright © 2021 I-Connect007. All rights reserved.