Ampel Inc. Acquires Image Circuit Inc.


Reading time ( words)

Ampel Inc. has acquired Image Circuit Inc., a PCB fabricator based in Elgin, Illinois. Ampel is a 35,000 square-foot PCB fabricator headquartered in Elk Grove Village, Illinois.

Image Circuit’s day-to-day operations are expected to remain the same. The company will also retain its e-mail addresses, phone numbers and fax numbers:

E-mail: sales@imagecircuit.net
Phone: 847-622-3300
Fax: 847-622-2700

All payments and other correspondence should be sent to Image Circuit’s new business address:

Image Circuit Inc.
925 Estes Ave.
Elk Grove Village, Illinois, 60007
www.imagecircuit.net

For more information about Ampel Inc., visit www.ampelinc.com

Share




Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

05/13/2022 | Nolan Johnson, I-Connect007
The big news in the industry this week was the new bill introduced to the U.S. Congress in support of the PCB manufacturing industry. The Supporting American Printed Circuit Boards Act of 2022, which was introduced by Reps. Anna Eshoo (D-CA) and Blake Moore (R-UT), incentivizes “purchases of domestically produced PCBs as well as industry investments in factories, equipment, workforce training, and research and development.” The bill is a PCB-oriented complement to the semiconductor-oriented CHIPS Act of 2021.

The Carbon Footprint of HDI: Direct Metallization vs. Electroless Copper

04/14/2022 | Jordan Kologe and Leslie Kim, MacDermid Alpha Electronics Solutions
As the electronics supply chain contends with the struggles of moving out of the pandemic and into a new normal, it is increasingly obvious that a new normal will be one with sustainability and resource conservation as the top priority. Over the past year, we have seen printed circuit board manufacturers encounter challenges associated with environmental regulations, water and power outages, and pressures from the supply chain to reduce environmental footprints. From the perspective of a board fabricator, especially one that specializes in HDI, a highly resource-intensive step in the process of making a printed circuit board is the primary metallization step. All circuit boards that have multiple layers go through such a primary metallization, which is either electroless copper or direct metallization (DM).

Uncovering the Electronics Ecosystem

04/08/2022 | Nolan Johnson, I-Connect007
Nolan Johnson speaks with Will Marsh, vice president of TTM Technologies and president of the Printed Circuit Board Association of America, about the work the PCBAA has been doing in Washington, D.C., to get the industry better recognized by the country’s decision-makers. Marsh is optimistic, not only about the companies and individuals joining the effort, but in the recognition by Capitol Hill to secure the nation’s defense systems.



Copyright © 2022 I-Connect007. All rights reserved.