PNC Inc. Invests in LED Laser Direct Imaging system from Miva Technologies


Reading time ( words)

This 2000L 2LE model is capable of imaging a maximum size 24” x 24” PC board or film size. With any large format film, positional accuracy can be a challenge but the Miva’s dynamic scaling feature can increase accuracy to minimize tolerance build-ups during the imaging process. Due to Miva’s optical registration system, innerlayer drill break-out will be reduced considerably on densely routed signal layers which will significantly improve yields. For sub-20-mil pitch parts or micro BGAs, a 2−3 mil solder dam will be possible to eliminate bridging during the assembly process.

“This LDI system represents a culmination of our efforts to find the most efficient equipment for each and every department in both manufacturing and assembly,” said PNC Inc. President, Sam Sangani.

Again, PNC stands by its commitment to quality and continuous improvement. Taking this next step to improve the manufacturing process helps them deliver the ever-increasing quality standards which they have become well known for.

About PNC Inc.

PNC Inc. is located in Nutley, NJ and is one of the country’s leading providers of rigid, rigid-flex and flex PCBs and the largest of their kind in the region. After adopting the Total Concept philosophy, PNC is now able to provide customers with PCB design, fabrication and assembly solutions all under one roof. PNC is a one-stop shop for all things related to PC boards, continuously expanding an extensive list of state-of-the-art equipment while maintaining a focus on energy and cost efficiency in order to provide the best product at the best price possible.

PNC Inc.’s ownership recently acquired Accurate Engineering Inc. in Sun Valley, CA. AEI’s primary focus is on high quality flex and rigid-flex PC boards for highly complex applications including aerospace and defense. Customers include Northrop Grumman, Boeing, Lockheed Martin, NASA and Raytheon.

Share

Print


Suggested Items

Solder Mask Curing: UV Bump Overview

08/19/2019 | Nikolaus Schubkegel
Ultraviolet (UV) bump, also called UV cure, is a processing step in which the solder mask pattern is irradiated with ultraviolet and infrared light. This step is performed with special equipment that is built as a continuous flow system, which consists of a conveyor belt and tubular UV lamps mounted above and below the belt. Read on to find out more about this process.

A Guide to High-reliability PCBs from Design to Specification

07/24/2019 | Jeff Beauchamp, NCAB Group
Creating reliable PCBs is an outcome of considering all aspects that can affect reliability as early as possible in the design process. The further down the design process, the more expensive and risky it can be to fix. As they say, everything starts with the design. Because a good board design improves the reliability of the end product and lessens the risk of failure.

How Changing Cleaning Technologies Affect Reliability

07/22/2019 | Andy Shaughnessy, I-Connect007
At the recent IPC High-Reliability Forum and Microvia Summit, Andy Shaughnessy spoke with Michael Konrad, founder and president of Aqueous Technologies and a speaker and panelist at the event in Baltimore, Maryland. They discussed Konrad’s presentation and the recent proliferation of cleaning, from solely high-reliability products to Class 1 consumer products.



Copyright © 2019 I-Connect007. All rights reserved.