RTW IPC APEX EXPO: Prototron Moves Offshore


Reading time ( words)

Prototron's Dave Ryder and Russ Adams discuss the company's recent decision to begin manufacturing high-volume jobs overseas. They also discuss some of the partner shops' capabilities, including flex and rigid-flex, which were driven by customer demand.

To watch this interview, click here.

Share


Suggested Items

Increasing Productivity for Flex Fabricators

11/14/2018 | I-Connect007 Editorial Team
Barry Matties and Nolan Johnson of I-Connect007 met with Shane Noel and industry veteran Mike Jennings of ESI to discuss the introduction of their CapStone laser tool, a product aimed at doubling their flex circuit fabricators’ throughput. Mike also shares advice for fabricators who are looking to move into the ever-growing flex market.

Atotech on Challenges and Opportunities in PCB Manufacturing

09/04/2018 | Stephen Las Marias, I-Connect007
Abel Ruivo, Atotech Deputy Business Director of Electronics for Greater China, and Daniel Schmidt, head of Global Marketing for Electronics at Atotech Group, spoke with I-Connect007 about the various challenges of PCB manufacturing in China, as well as about the opportunities in the sector.

Flex Time: Why is Rigid-Flex So Expensive?

07/11/2018 | Bob Burns, PRINTED CIRCUITS
One question that I hear fairly often, particularly after an initial quotation, is “Why is rigid-flex so expensive?” In this article, I’ll share with designers the cost drivers in rigid-flex relative to standard rigid boards and flex circuits with stiffeners. A typical rigid-flex PWB will cost about seven times the cost of the same design on a hard board, and two to three times an equivalent flex circuit with stiffeners.



Copyright © 2018 I-Connect007. All rights reserved.