ACI Completes AS9100D/ISO 9001:2015 Assessment Audit


Reading time ( words)

Advanced Circuitry International, specialists in RF/microwave and antenna PCBs, is pleased to announce that it has successfully completed the AS9100D/ISO9001:2015 assessment audit at its facilities located in Atlanta, Georgia.

Bryan Ricke, director of sales and business development, states, "Having an ISO9001:2008 QMS system has served our needs and the needs of our customers for many years. While ACI has historically serviced a commercial customer base fabricating RF/microwave and antenna PCBs, we have seen increasing interest from the aerospace and defense community for our products and technology. Based on that interest we have made the commitment to upgrade our QMS system to AS9100D/ISO9001:2015."

About Advanced Circuitry International

Advanced Circuitry International is a world class supplier of RF/Microwave and Antenna PCB’s. We have four state-of-the-art facilities on three continents to serve our customers. From rapid prototype development to large scale production ramp-ups we supply many notable OEM’s and EMS service companies around the world.

Advanced Circuitry International 3424 & 3464 Howell Street, Duluth, GA*770.622.2200

For more information, click here

Share

Print


Suggested Items

EPA, Industry Come Together in Visit to TTM Facility

07/18/2019 | Kelly Scanlon, director, EHS policy and research
IPC member TTM Technologies is proud to show off the new wastewater-treatment system at its Sterling, Virginia plant, which is helping to enhance the company’s pollution prevention and resource recovery performance.

Dissecting the IPC Regional Survey on PCB Technology Trends

07/15/2019 | I-Connect007 Editorial Team
Sharon Starr, Denny Fritz, and Mike Carano talk about the global 2018 IPC Technology Trends Report released early this year—the size of the survey, how it was conducted, the general findings, and regional differences. They also shared their takeaways and regional insights, and the industry outlook over the next five to 10 years.

Identifying Product Board Class and Pre-quote Software

07/09/2019 | Mark Thompson, CID, Prototron Circuits
Deciding on the class of the final product will determine what files are needed for fabrication and assembly. It is critical to note that for a product to be built to any class level, it must be designed to that class level from its inception.



Copyright © 2019 I-Connect007. All rights reserved.