FKN Systek's N100 Nibbler Available with Three Blade Types


Reading time ( words)

Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Three blade types are available in standard thicknesses of 0.120 in, 0.093 in and 0.062 in.

Custom sizes to match the width of the routed section can be ground on request. Tabs up to 0.324” (8.23 mm) are cut cleanly on each side so that no further clean-up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.

The N100 is provided with a quick-connect pneumatic port which plugs directly into factory air (80-100 PSI). Stepping on a foot pedal activates the cutting process. The excess material from the tab is stored inside a compartment of the tool and can be easily removed at the convenience of the operator. To see a video of the N100 and other depaneling methods go to fknsystek.com.

The Sharp Blade support dies of the N100 provide a clean shearing action, ideal for singulating one tab at a time on flex circuit boards. This is the perfect tool for low volume singulation of a variety of flex circuit and standard PCBs built on a rectangular pattern.

Come by booth 107 at SMTAI Rosemont, September 24 and 25 to see FKN Systek Depaneling tools. Bring samples for evaluation.

Share

Print


Suggested Items

Advantages of Using ZIF Connectors as a Termination Method

03/17/2020 | All Flex
There are many types of connectors and termination methods available when designing a flexible circuit. One of the most common is the zero insertion force (ZIF) connector. The reason why the ZIF connector is so popular is that they eliminate the requirement for an added connector. They create a direct connection from the circuit to the mating connector reducing overall weight and cost. Here are a few general facts about ZIF connectors.

Flexible Circuit Design Guidelines

03/05/2020 | Flexible Circuit Technologies
Flexible circuit designs share many of the same challenges of rigid PCB designs, but there are also many differences and additional challenges. The very nature of a flex circuit being able to bend and flex make it as much a mechanical device as an electrical one. This creates a special set of requirements unique to flexible circuitry. Understanding how these requirements interact will allow the PCB designer to create a flex circuit that balances the electrical and mechanical features into a reliable, cost-effective interconnect solution.

Catching up With Flexible Circuit Technologies

02/14/2020 | Dan Beaulieu, D.B. Management Group
Dan Beaulieu catches up with Troy Koopman, president and co-founder of Flexible Circuit Technologies (FCT), and Carey Burkett, the company’s VP of business development. FCT is a full-service flex and rigid-flex supplier.



Copyright © 2020 I-Connect007. All rights reserved.