NCAB Group Seminar on Challenges of Miniaturization's Densification for PCBs


Reading time ( words)

The NCAB Group will be holding a free seminar about the challenges of the miniaturization’s densification for PCBs. The seminar will be held on November 13, 2019, from 1:30–4:30 p.m., at the NCAB Benelux office in Den Bosch, Het Sterrenbeeld 42.

Among the topics for discussion are HDI design rules to help on density; rigid-flex for more components and better reliability; and DFM (design for manufacture) improvements.

The seminar will be in English.

Share

Print


Suggested Items

Decreasing Bend Radius and Improving Reliability- Part III

12/18/2019 | Kelsey Smith, All Flex
Application: Design guidelines to improve the flexibility and reliability of flexible circuits. Most issues that arise with flex circuits can be eliminated in the early stages of the design phase, and special planning must occur when the circuit is required to bend. Many novices will design a circuit that calls for bending the flex in too tight of a bend radius, which can cause damage to the circuit and lower the reliability of the end product.

Flex Standards Update With Nick Koop

11/21/2019 | Andy Shaughnessy, Design007 Magazine
This month, I interviewed Nick Koop—director of flex technology at TTM Technologies, a veteran “flex guy” and instructor, and a leader of several IPC flex standards committees. Nick provides an update for the committees he’s involved with and discusses some of the challenges that he sees as more designers enter the world of flex.

Decreasing Bend Radius and Improving Reliability—Part I

10/11/2019 | Kelsey Smith, All Flex
Many of the issues that arise when using a flex circuit come from a lack of knowledge about how to properly design one, especially when the circuit is required to bend.



Copyright © 2020 I-Connect007. All rights reserved.