Why PCB Fabricators Need to Be at the SMTA Additive Electronics Conference


Reading time ( words)

When I-Connect007 asked Tara Dunn, Omni PCB president and conference co-chair, about the types of applications discussing or adopting additive PCB technology, she replied, "Applications that need extremely thin copper, are concerned with space and weight, and have complex pin-outs, pushing the capabilities of traditional PCB manufacturing, could utilize SAP or mSAP technology. If you’re not using this kind of technology now, the chances are good that you will be soon."

Tara will also be attending and moderating a panel discussion at the conference.

Don’t miss out; start your research. Attend the SMTA Additive Electronics Conference on October 24, 2019, to launch your expertise in additive electronics.

Share

Print


Suggested Items

Why Designers Need to Be at the SMTA Additive Electronics Conference

10/18/2019 | I-Connect007
In a recent interview, Kelly Dack and Tara Dunn (Omni PCB president and conference co-chair) discussed why designers need to attend the SMTA Additive Electronics Conference. Tara will also be attending and moderating a panel discussion at the conference.

SMTA Additive Electronics Conference: Industry Trends

10/10/2019 | I-Connect007
Mainstream PCB manufacturing is often limited to 50-75 microns (mm) line and space. But the electronics industry is evolving quickly. Propelled by the demand for more sophisticated electronics, PCB design is being tasked with finer lines, thinner materials, and smaller via sizes.

Additive Electronics Conference Set for October 2019

09/18/2019 | I-Connect007 Editorial Team
Tara Dunn, president of Omni PCB and I-Connect007 columnist, and Lenora Clark, director of autonomous driving and safety technology at MacDermid Alpha Automotive, discuss what can be expected from the upcoming Additive Electronics Conference in San Jose, California, the impetus and motivation behind the conference, and who can benefit the most from attending.



Copyright © 2019 I-Connect007. All rights reserved.