Polar Talks Impedance and Insertion Loss Testing


Reading time ( words)

Product Specialists Michael Bode and Geoffrey Hazlett join Guest Editor Dan Feinberg to talk about the company and its products and solutions. They also talked about some of the technologies being enabled by the company, including controlled impedance and insertion loss testing.

Watch the interview here.

Share




Suggested Items

The Survey Said: Designing Around Missing Data

06/09/2022 | Andy Shaughnessy, Design007 Magazine
One of the best tools we have for keeping our fingers on the pulse of the industry is the reader survey. When we want to find out what’s going on, we just ask. Fortunately, our readers are not a shy bunch of folks. They don’t mind sharing—the good, the bad, and the ugly. In a recent survey, we asked our PCB designer readers, “What missing information or data (impedance requirements, library data, etc.) do you find yourself having to ‘design around’?”

A Textbook Look: Signal Integrity and Impedance

05/18/2022 | Pete Starkey, I-Connect007
Believing that I knew a bit about signal integrity and controlled impedance, I was pleased to take the opportunity to connect with an educational webinar that I hoped would extend my knowledge. In the event I was surprised at how little I actually knew, and the webinar was an excellent learning opportunity. The webinar was introduced and expertly moderated by Anna Brockman of Phoenix Contact in Germany.

AltiumLive 2022: Power and Signal Integrity—Return to Sender

02/23/2022 | Andy Shaughnessy, Design007 Magazine
I recently spoke with Heidi Barnes and Stephen Slater, both engineers with Keysight Technologies, about their presentations at this year’s virtual AltiumLive. They discussed ways to avoid signal and power integrity challenges later by following simple board design practices early on, how SI and PI are interconnected, and why the return path must be more than an afterthought in high-speed designs.



Copyright © 2022 I-Connect007. All rights reserved.