New PCB Conference at 2015 IPC & APEX South China Fair


Reading time ( words)

The 2015 International Printed Circuit & APEX South China Fair, which will be held from December 2-4, 2015 at the Shenzhen Convention & Exhibition Center in Shenzhen, China, will highlight the PCB GIGA Conference – a professional, high-profile industry conference that aims to offer practical solutions and useful insights for industry players to better equip themselves for a sustainable development of the industry.

To be presented in versatile formats in keynote speech, panel discussion and case studies, the PCB GIGA Conference has been strategically divided into the following four themes:

  • Market Evolution (December 2)
  • Green Solutions (December 3)
  • Smart Automation (December 3)
  • Flexi & Ceramic PCB Market Trend (December 4)

The PCB GIGA Conference will provide attendees an update on market outlook and challenge; smart automation development in the semiconductor industry; global market trend forecast; and PCB application trends in key segments.

For more information and to pre-register, visit www.hkpca-ipc.show.org.

Share

Print


Suggested Items

Dissecting the IPC Regional Survey on PCB Technology Trends

07/15/2019 | I-Connect007 Editorial Team
Sharon Starr, Denny Fritz, and Mike Carano talk about the global 2018 IPC Technology Trends Report released early this year—the size of the survey, how it was conducted, the general findings, and regional differences. They also shared their takeaways and regional insights, and the industry outlook over the next five to 10 years.

An Examination of Glass-fiber and Epoxy Interface Degradation in Printed Circuit Boards

07/12/2019 | Bhanu Sood, Michael Osterman, and Michael Pecht, Center for Advanced Life Cycle Engineering
Multilayer organic laminates, which make up over 90% of the interconnecting substrates in electronics (standard FR-4 represents 85% of the substrates used for laminates), can develop a loss of electrical insulation resistance between two biased conductors due to conductive filament formation.

Identifying Product Board Class and Pre-quote Software

07/09/2019 | Mark Thompson, CID, Prototron Circuits
Deciding on the class of the final product will determine what files are needed for fabrication and assembly. It is critical to note that for a product to be built to any class level, it must be designed to that class level from its inception.



Copyright © 2019 I-Connect007. All rights reserved.