Reading time ( words)
Matrix has sold four Hakuto Mach 630NP Auto Dry Film Laminators to TTM, following a successful four-month trial.
Matrix is extremely pleased with the performance of Hakuto’s new Mach 630NP/6630NP Series Dry Film Laminators and is prepared to provide sales and service to all regions of North America.
Fred Long, Matrix Business Development, says, “The new Mach 630NP machine addresses the accuracy needed to assist in the transfer of very fine lines on the latest HSLL laminates using Super Low Profile Copper surfaces. This is made possible by the new Lamination Module with its EVEN Heat and EVEN Pressure across the entire surface of the laminated panel. In addition, the ability to change the rubber lamination rolls in seconds will not only increase productivity but will also offer alternative “quick change” rubber solutions for different product needs. The complete redesign of the film lamination approach will now begin to reach the most important users of this latest technology. Matrix is eager to show manufacturers that by using the new system, Productivity and Yield will now surpass all traditional ROI expectations.”
To watch the Real Time With...IPC interview with Dan Feinberg and Fred Long discussing the new laminating machine and its innovative features, click here.
During the next few weeks, Matrix is scheduled to place additional machines in three specific regional areas in the US. Customers will then be able to travel to these sites and see the machines in operation.
About Matrix USA Inc.
Committed to the motto, “Quality Products, Dependable People”, Matrix was established in 1977 with the objective of providing quality raw materials to the North American Printed Circuit Board Industry. Matrix has four rapid-response warehouses located throughout the US and Canada that fulfill high quality, fast delivery, and custom orders daily. For further information, click here.